COVID-19 MASK v2 (Fast print, no support, filter required)
This is a 3D-printable mask designed for rapid production and ease of use. The mask body is contoured to fit snugly over the nose and mouth, and the design incorporates a modular filter system, allowing for the insertion of various filtration materials. The mask is secured with straps that loop around the head, ensuring a tight seal. This design emphasizes functionality and quick deployment, making it ideal for situations where personal protective equipment is needed urgently.
How to print it
- Material
- PETG, not PLA — a mask is stored until it is needed, then worn for hours and washed in hot water. PLA loses roughly 14% of its tensile strength in 90 days in a cool, humid cupboard and softens at 61C in a hot car. PETG holds to about 80C and still prints on any open-frame printer.
The spool for this print
PETG Filament, 1.75mm (1kg)
Handles heat, sun and load without an enclosure. The default for gear that leaves the house.
Check PETG on AmazonAs an Amazon Associate we earn from qualifying purchases, at no extra cost to you.
About the design
This mask is particularly useful for preppers and survivalists because it can be printed on demand, providing a crucial layer of protection in situations where access to conventional masks is limited. The ability to use different filter materials means it can be adapted for various threats, from dust and smoke during natural disasters to potential airborne contaminants. Its rapid print time and support-free design mean it can be produced quickly with minimal material waste, even in austere environments. The mask could be essential in situations like wildfires, pandemics, or even just dusty work conditions where respiratory protection is needed. Consider printing a few of these masks and storing them with your emergency supplies to ensure you and your family are prepared.
Credit and licence
COVID-19 MASK v2 (Fast print, no support, filter required) by lafactoria3d · Thingiverse · CC BY-NC-SA 4.0
We don’t host this file. The model belongs to its creator; the material and print advice on this page is ours.
Licence checked Sep 2026Tags
- coronavirus
- covid-19
- FaceCoveringChallenge
- filter
- FILTRO









